Avalon Camano Owner's Manual download pdf (Page 30)

30 Optional Equipment

Rear Blower Installation (Part # 99000138)

The rear blower improves heat transfer by pushing heated air through the convection channel. Operating

instructions are described in the section "Blower Operation".

Twist the wires together and feed

them through the convection chamber

and out of the slot on the rear of the

stove (either side).

Attach the wires from

the thermodisk to the

wires from the blower.

Attach the blower to the stove with the

three screws included with the blower.

Position the blower near the rear of the stove. Tuck all excess wire into the

blower box, making sure it does not contact any moving parts. Make sure when

installing the blower, these wires do not become loose.

3/8" Wrench

Plug the blower in. Do not route the power cord under or over the stove or in a

location where it may become damaged.

Ashlip

Wedge the snap disk directly

in front of the stiffener on the

left side.

Bend these legs on the snap

disk if it does not fit tightly

Snap Disk

Assembly

Remove all slack from the wire and

secure with the included wire clip.

Wire Clip

Snap Disk Wires

WARNING:

To prevent electrical shock,

the wires must be secured

so they do not contact the

firebox above the

convection channel.

1 2 ... 25 26 27 28 29 30 31

No comments

Avalon Camano Owner's Manual Page 30