Avalon Camano Owner's Manual download pdf (Page 17)

Stove Installation (for qualified installers only) 17

© Travis Industries 100-01252_000 4101004

Hearth Stove Direct

Connection

NOTE: This type on

installation is not

allowed in Canada.

NOTE:

Direct connections require

installation of an airtight,

non-combustible block-off

plate or damper adapter.

Block-off plate or

damper adapter

Remove damper

or wire it open

Airtight

Insulated

Clean-Out

Stainless steel

chimney connector

must Extend 1' past

the block-off plate or

to the flue liner

NOTE: The chimney must have a clay tile

liner. If it does not, the installation must use

a positive connection (full reline). The entire

fireplace and chimney must be clean,

undamaged, and meet all local building

codes (UBC, etc.). Damage must be

repaired prior to installation. The chimney

must be 15' (4.57M) to 33' (10.05M) tall.

Clay

Liner

Floor Protection

(See the section

"Floor Protection

Requirements" for

more details)

Combustible Mantle

Min. 18"

(457mm)

See the section

"Stove Placement

Requirements" for

minimum clearances

required.

Figure 14

Interior or Exterior

Masonry Chimney

NOTE: This type on

installation is not

allowed in Canada.

NOTE:

This type of installation

requires a UBC approved

masonry connector or

other method approved by

the NFPA 211 standard.

See Chimney Connector

Requirements on page 10

for further details.

Make sure the

clean-out seals in

place.

Clay Liner

See the section "Stove

Placement Requirements" for

minimum clearances required.

Min. 18"

(457mm)

clearance

to ceiling

This type of

installation requires

a UBC approved

masonry connector

or a factory built

(U.L. Listed) wall

thimble.

Chimney connector sections

NOTE: The chimney must have a

clay tile liner. If it does not, the

installation must use a positive

connection (full reline). The entire

fireplace and chimney must be

clean, undamaged, and meet all

local building codes (UBC, etc.).

Damage must be repaired prior to

installation. The chimney must be

15' (4.57M) to 33' (10.05M) tall.

See the section

"Floor Protection

Requirements"

Figure 15

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Comments to this Manuals

No comments